DYNOmite Rotary-Torque Transducer Specifications

DYNOmite Data-Acquisition Computer:**

**Not included in 0-5 volt transducer kits
Expandable, surface mount, board system runs on 120-volt 60-Hz AC, 240-volt 50-Hz AC, or 12-volt DC
“Pro” PC based 28, 56 or 112+ channel capable board sets, require DYNO-MAX software
“Lite” 3-channel (upgradeable to “Pro” above)
Optional portable “Pro” 28-channel capable handheld with 168-character LCD & keypad
Up to 1,000 recordings per second (per channel)
Quick disconnect data harness
Non-volatile set-up memory
Rechargeable back-up battery option
Captures over 1-hour duration test runs
Real time and data playback displays
Observed and SAE corrected reports
“Smart Record” automated recorder triggering
RS-232 or USB output to optional printer or PC with DYNO-MAX 2000 software option 

DYNOmite Rotary Interface Module:

Requires 12-volt DC at 3 amps
Interfaces receiver's pick-up coil to data-acquisition computer
Shielded data wire for ignition noise protection

Torque Transducer (shaft mounted):

Standard - GM, Ford or MoPar automotive yoke
Optional - custom mounting on almost any shaft (if over 3/8" diameter) available
On-board microprocessor computer
Wireless coupling (no brushes, slip-rings, or batteries) digital data communication
Environmentally sealed surface mount electronics
Torsional strain gauges in full bridge circuit
2% of full scale typical accuracy
Semi-automatic zero offset calibration
Transducer temperature drift compensation

Receiver Pick-Up Coil:

Popular automotive transmission tail-shaft mounted units - (standard)
Optional custom made units available
Band clamp mounting

Hp, Torque, and RPM Capacity:

Torque and Hp mechanically limited only by selected driveline component’s capacity - custom units to any range!
9,999 Hp LCD display limit
9,999 lb-ft LCD display limit
Standard automotive driveshaft transducers rated to 10,000 RPM
Optional transducers to over 15,000 RPM

Engine Tachometer:**

0 - 32,000+ RPM
    Optional LCD display
Quartz crystal calibrated
RPM pulse type is selectable from ½ to 12 pulses per revolution
Optional magnetic absorber pick-up available
Optional “clamp-on” inductive pick-up available
**Not included with 0-5 volt transducer kits

Vehicle Speedometer:**

Infrared pick-up - standard
0.0 - 255.0 MPH Optional LCD display
Quartz crystal calibrated
RPM pulse type is selectable from 1 to 240 pulses per revolution
Optional magnetic pick-up available
**Not included with 0-5 volt transducer kits

Optional Portable Thermal Printer:

Rechargeable NiCad battery powered
120-volt AC charger adapter included
Parallel port interface to DYNOmite-Pro
40 column standard ASCII font
Rugged, compact, and lightweight design 

Dimensions and Approximate Weight:

Standard Transducer -
    3-¾" OD x 7/8