Eddy Current Equipment - Specifications

Optional DYNOmite Data-Acquisition Computer:

Expandable, surface mount, board system runs on 120-volt 60-Hz AC, 240-volt 50-Hz AC, or 12-volt DC
“Pro” PC based 28, 56 or 112+ channel capable board sets, require DYNO-MAX software
“Lite” 3-channel (upgradeable to “Pro” above)
Optional portable “Pro” 28-channel capable handheld with 168-character LCD & keypad
Up to 1,000 recordings per second (per channel)
Quick disconnect data harness
Non-volatile set-up memory
Rechargeable back-up battery option
Captures over 1-hour duration test runs
Real time and data playback displays
Observed and SAE corrected reports
“Smart Record” automated recorder triggering
RS-232 or USB output to optional printer or PC with DYNO-MAX 2000 software option 

Torque Transducer:

Type, performance, range, etc. vary with each application; call for exact specifications
S-beam load cells with full bridge strain gauges
Environmentally sealed
½% of full scale typical accuracy
Semi-automatic zero offset calibration
Temperature compensated
Optional wireless rotary-torque transducers available (see DYNOmite On-Board Dynamometer literature for details)

Hp, Torque, and RPM Capacity:

*Actual air-cooled eddy current capacities are RPM and absorber temperature dependent. Initial cold rotor torque and Hp capacities are approximately twice the hot rotor Hp capacities shown below (taken after running 10 minutes, at full load, in a room temperature environment). Continuous ratings will be approximately 50% of these hot values.
“Micro” up to 1 Hp hot (¼ Hp min.)*
“Mini” up to 3 Hp hot (¾ Hp min.)*
#20 up to 20 Hp hot *
#100 up to 100 Hp hot *
#15